Follow

Setting up the Evosk Stand

Please see the steps below to set up the Evosk stand.

Step 1: Screw in both side panels into the base using 6 of the wingnuts.Screen_Shot_2017-12-05_at_9.54.22_AM.png

Step 2: Slide in both front and back panels. Make sure that both panels are flush before locking them into place.

Screen_Shot_2017-12-05_at_9.55.03_AM.png

Step 3: Screw in the top panel using 6 flathead screws.

Screen_Shot_2017-12-05_at_9.55.45_AM.png

Step 4: Place the top of the Evosk to the lower portion so that it sits at a 100 degree angle. Make sure that the lower front panel with the four pegs for the keyboard tray matches with the front side of the top section. Once it all matches, twist into place so that it is flush with one another.

Screen_Shot_2017-12-05_at_9.56.23_AM.png

Step 5: Unlock the back to the top portion of the Evosk. Place badge printer into the kiosk with the badge stock lying below it.

Screen_Shot_2017-12-05_at_9.57.24_AM.png

Step 6: Plug USB cable from the bluetooth scanner into the power strip that is located in the top corner of the Evosk.

Screen_Shot_2017-12-05_at_9.58.08_AM.png

Step 7:  Make sure power strip cable, badge printer power cord and ethernet cable are fed through the lower left divet before locking the back of the Evosk.

Screen_Shot_2017-12-05_at_9.58.56_AM.png

Step 8: Plug the iPad charger into the power strip and feed it through the slot beneath the iPad base on the front of the Evosk.

 

Screen_Shot_2017-12-05_at_9.59.36_AM.png

Step 9: Prior to placing the iPad into its metal casing, screw in the back portion of the metal casing onto the iPad base using 4 wingnuts and 4 roundhead screws.

Screen_Shot_2017-12-05_at_10.00.49_AM.png

Step 10: Place the front half of the iPad case (with iPad locked in) onto its back portion. Make sure to feed the iPad charger through the metal casing before locking it.

Screen_Shot_2017-12-05_at_10.03.24_AM.png

Step 11: Slide keyboard tray onto the front of the Evosk.

Screen_Shot_2017-12-05_at_10.04.04_AM.png

Step 12: Place lanyards onto lanyards holders along either side of the Evosk. 

Screen_Shot_2017-12-05_at_10.05.13_AM.png 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments